Six Steps for Maintenance of Packaging Machinery

Carton packaging machinery is suitable for continuous complete of various cartons. There are usually 30 and 40 types. The heat sources are coal or firewood type and electric heating type. It is the most commonly used machine in carton processing. The main points of maintenance and maintenance are as follows:

1. Replace the lubricating oil in worm gear and worm reducer of carton packing machine. The lubricating oil can be No. 10, No. 20 or No. 30.

2. After repairing the parts, the whole unit is assembled and the machine is turned on to observe whether the machine is working properly. The drum is heated properly, and a small amount of special oil for carton packaging machinery is put into it to melt and cover the inner surface of the drum, then cut off all the power supply. When necessary, the machine can be sprayed with paint on the surface, and then covered with plastic paper after drying. The machine can be stored in a drying place.

3. If the chain is too loose, adjustments can be made by removing several adjustments. If it has been seriously elongated, it should be replaced. In the use of carton machinery, it is necessary to use according to a certain amount of methods and principles, maintain and maintain according to a certain way, solve different problems in time, adjust and replace the chain should pay attention to: the installation direction of the spring card at the joint of the chain should be consistent with the direction of the chain operation, so as to avoid impact during operation. It jumps and even crashes and falls off. www.chinacartonmachine.com

4. Calcium-sodium base grease can be used to remove and wash all rolling bearings and add new grease.

5. Clean up dirt on all friction surfaces, especially on chains and sprockets, and refill lubricants.

Maintenance and maintenance of carton packaging machinery require certain technicians to maintain and repair, ensure the quality and performance of carton machinery in use, and play an important role and value in the production of cartons.

6. Check whether the stove leaks smoke or not. If smoke leaks are found, the drum stove, stove and chimney should be inspected, and the damage should be repaired and replaced in time. Electric heat engine type should check whether the electric heat pipe is damaged or not, and if damaged, it should be replaced.

 

 

Inquiry for Our Product

When you contact us, please provide your detail requirements.
That will help us give you a valid quotation.

1. Your Name *
2. Your E-mail *
3. Message *