The common problems and solutions of the full automatic carton die cutting machine

The common problems and solutions of the full automatic carton die cutting machine
Now with the carton products have become increasingly demanding, the application of automatic die cutting machine in the carton packaging industry is more and more widely. However, due to the lack of operational personnel maintenance knowledge, resulting in a lot of equipment failure, which also directly affect the normal operation of the equipment, so that production costs.
For equipment, if not do a good job of maintenance, not only disrupted the production and installation plan, also has a great impact on the delivery period. In order to improve the operation process of automatic die cutting machine further, new technology play die-cutting machine better, improve the modernization level of the operation, maintenance and maintenance of the knowledge points for some of this equipment is to get attention. www.chinacartonmachine.com
 

Operators need to pay attention to dust and clean, in the actual production, die-cutting carton when will produce large amounts of waste paper, paper edge hair, if a little attention will enter into the chain of transmission parts, the moving platform and die-cutting part rotary motion parts, and may be shielded by a photoelectric detection head, resulting in failure. So to the machine body cleaning work in the first place, it is possible to ensure that the machine can operate without failure.
There is a flat die-cutting machine oil, the main action of cutting machine is the main motor drives the slide rod and a pulley, drives four side elbow to move, to reach six thousand per hour at a high speed in the work, if there is no good lubrication and cooling is very troublesome.
Maintenance of equipment of die-cutting machine is every operator must do, because the machine was not maintained, will increase the maintenance cost, and also has a lot of damage to machinery and equipment, shorten the service life of the machine. Another is that it will affect the operation, and delay in production. So mechanical failure will affect many aspects, the need for timely elimination.
Finally, for the common failure of the die - cutting machine should be promptly removed. Mechanical failure, automatic die cutting machine are common platform and compression phenomenon. This situation is due to foreign bodies into the die-cutting, usually take two block position, drag the shaft at the same time, the rotation of the platform to the limit point.
And the relative position of the upper net platform is also detected, and the distance between the four angle of the moving platform and the three net platform is ensured. This will solve the problem. For the electrical fault are, for automatic die-cutting machine center control system uses a programmable logic controller, is the main gas detection point switch and output actions must be based on it, and PLC its internal procedures for the ladder logic diagram.